Instructions for wireless remote control

Wireless remote control is divided into receiver and remote control transmitter

1、Function and connection method of remote control receiver

working voltage

12V volume: 80 * 50 * 38mm

working frequency

315MHz

Working function

Automatic learning function

transmission distance

> 1000m (the sensitivity of receiving board in open area is more than - 103dbm)

Connection method

1The 12vd GND is connected to the DC 12V power supply (it can share the power supply with the DC12V camera)

A. Connection of RS485 function

Rs485a connected to RS485+

Rs485b connected to RS485-

B 232ttl connection

TX RX connected to camera

RX TX connected to camera

GDN connected to GND (if the shared power supply can not be connected, otherwise GDN must be connected)

2, check the code

Self learning recognition remote controller

A press once, release, press key 1 with the remote control to trigger continuously and recognize the remote control

B press continuously for 10 seconds to clear all remote records

3Definition of indicator light

The indicator lights are yellow red blue green

yellow

12V indicator light

red

5V indicator light

blue

Receiving indicator

green

Send indicator

2、The remote control is divided into 6 keys (operation function) and 8 keys (operation function + debugging function)

1No. 1 button --- enlarge

2No. 1 button -- zoom out

3Key No. 1 - telephoto

4No. 1 button - near focus

5Key No.: manual / auto focus switch

6Key No. --- empty (function reserved)

B 8 key remote control function introduction:

8The No. 2 remote controller has another mode of operation and debugging, the function switch key is No. 6 key, the short press is the operation mode, and the connection press for 2-3 seconds to enter the mode.After debugging, you need to press the No. 6 key briefly to enter the operation function and use it normally!

Operation mode function:

1No. 1 button --- enlarge

2No. 1 button -- zoom out

3Key No. 1 - telephoto

4No. 1 button - near focus

5Key No.: manual / auto focus switch

6Key No.: function mode switching

7Button No.: increase of brightness (customizable)

8No. 1 button --- brightness reduction (customizable)

Debug mode function

1Key number: menu down

2Key number: menu up

3No. 1 button -- menu left

4Key number: right side of menu

5Press key No. 1 to enter the menu

6Key No.: function mode switching

7Button No.: full color mode (customizable)

8Key No.: infrared mode (customizable)